Milan FWD L4-2.5L (2010)
![background image](/mercury/milan_fwd/l4-2.5l/Page-2782002.png)
-
Connect a fused jumper wire between the stoplamp switch C278-1, circuit SBP02 (YE/RD), harness side and the stoplamp switch C278-4, circuit
CCB08 (VT/WH), harness side.
-
Do the stoplamps illuminate?
Yes
REMOVE the jumper wire. INSTALL a new stoplamp switch. REFER to Stoplamp Switch See: Brake Light Switch/Service and Repair. TEST the
system for normal operation.
No
REMOVE the jumper wire. REPAIR circuit CCB08 (VT/WH) for an open. TEST the system for normal operation.
-------------------------------------------------
I3 CHECK CIRCUIT SBP02 (YE/RD) FOR AN OPEN
-
Disconnect: SJB C2280d.
-
Measure the resistance between the stoplamp switch C278-1, circuit SBP02 (YE/RD), harness side and the SJB
C2280d-13, circuit SBP02 (YE/RD), harness side.
-
Is the resistance less than 5 ohms?
Yes
GO to I4.
No
REPAIR SBP02 (YE/RD) for an open. TEST the system for normal operation.
-------------------------------------------------
I4 CHECK FOR CORRECT SJB OPERATION
-
Disconnect all the SJB connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all the SJB connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new SJB. REFER to Body Control Systems. TEST the system for normal operation.