Milan FWD L4-2.5L (2010)
-------------------------------------------------
L1 DETERMINE IF ALL THE STOPLAMPS ARE ILLUMINATED
-
Ignition OFF.
-
Observe the stoplamps with the brake pedal released.
-
Are all of the stoplamps illuminated?
Yes
GO to L3.
No
GO to L2.
-------------------------------------------------
L2 CHECK THE SJB STOPLAMP OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE
-
Disconnect: SJB C2280d.
-
Do the stoplamps continue to illuminate?
Yes
If the LH rear lamp continues to illuminate, REPAIR circuit CLS18 (GY/BN) for a short to voltage. CLEAR the DTCs. REPEAT the self-test.
If the RH rear lamp continues to illuminate, REPAIR circuit CLS19 (VT/OG) for a short to voltage. CLEAR the DTCs. REPEAT the self-test.
No
GO to L7.
-------------------------------------------------
L3 CHECK THE STOPLAMP SWITCH
-
Disconnect: Stoplamp Switch C278.
-
Do the stoplamps continue to illuminate?
Yes
GO to L4.
No
INSTALL a new stoplamp switch. REFER to Stoplamp Switch See: Brake Light Switch/Service and Repair. CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
L4 CHECK THE PCM
-
Disconnect: PCM C175b.
-
Do the stoplamps continue to illuminate?
Yes
GO to L5.
No