Milan FWD L4-2.5L (2010)
Hose/Line HVAC: Service and Repair
Compressor Manifold and Tube Assembly
Compressor Manifold and Tube Assembly - 2.5L
Removal and Installation
NOTICE: Use only the Air Conditioning (A/C) refrigerant compressor oil specified for this vehicle configuration. Use of any A/C refrigerant
compressor oil other than what is specified will contaminate and damage the A/C system.
1. Recover the refrigerant.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
3. Detach the coolant reservoir hose retainers from the compressor manifold and tube assembly.
4. Remove the washer reservoir filler neck bolt.
-
To install, tighten to 6 Nm (53 lb-in).
5. Remove the compressor manifold and tube suction fitting nut and disconnect the fitting.
-
Discard the gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the gasket seal.