Milan FWD L4-2.5L (2010)
-------------------------------------------------
B2 CHECK THE ABS MODULE GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable .
-
For gasoline engine, measure the resistance between the ABS module C135-16, circuit GD123 (BK/GY), harness side and ground.
-
For hybrid engine, measure the resistance between the ABS module C135-16, circuit GD121 (BK/YE), harness side and ground; and between the
ABS module C135-47, circuit GD121 (BK/YE), harness side and ground.
-
Are the resistances less than 5 ohms?
Yes
For gasoline engine, GO to B3.
For hybrid engine, GO to B5.
No
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
B3 CHECK THE HS-CAN TERMINATION RESISTANCE
-
Disconnect the scan tool cable from the Data Link Connector (DLC).
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Is the resistance between 54 and 66 ohms?
Yes
GO to B5.
No