Milan FWD L4-2.5L (2010)
-
Fuse
-
Wiring, terminals or connectors
-
FDIM
PINPOINT TEST O: THE FDIM DOES NOT RESPOND TO THE SCAN TOOL
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
O1 CHECK THE FDIM VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: FDIM C2407 .
-
Ignition ON.
-
Measure the voltage between the FDIM C2407-12, circuit SBP14 (BN/RD), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
GO to O2.
No
VERIFY the Smart Junction Box (SJB) fuse 14 (10A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams to identify the
possible causes of the circuit short See: Diagrams/Electrical Diagrams/Diagrams By Number. CLEAR the DTCs. REPEAT the network test with the
scan tool.
-------------------------------------------------
O2 CHECK THE FDIM GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable .
-
Measure the resistance between the FDIM C2407-8, circuit GD116 (BK/VT), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes