Milan FWD L4-2.5L (2010)
-
Ignition OFF.
-
Disconnect: SOD-R C4229 .
-
Ignition ON.
-
Measure the voltage between the SOD-R C4229-5, circuit CBP35 (YE/GY), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
GO to S2.
No
VERIFY the Smart Junction Box (SJB) fuse 35 (10A) is OK. If OK, REPAIR the circuit in question. If not OK, REFER to the Wiring Diagrams to
identify the possible causes of the circuit short See: Diagrams/Electrical Diagrams/Diagrams By Number. CLEAR the DTCs. REPEAT the network test
with the scan tool.
-------------------------------------------------
S2 CHECK THE SOD-R GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable .
-
Measure the resistance between the SOD-R C4229-2, circuit GD171 (BK/GY), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to S3.
No
REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
S3 CHECK THE MS-CAN CIRCUITS BETWEEN THE SOD-R AND THE DLC FOR AN OPEN
-
Measure the resistance between the SOD-R C4229-4, circuit VDB06 (GY/OG), harness side and the Data Link Connector (DLC) C251-3, circuit
VDB06 (GY/OG), harness side.