Milan FWD L4-2.5L (2010)
-
For Sony(R) sound, measure the voltage between the audio DSP module, harness side and ground as follows:
-
Are the voltages greater than 10 volts?
Yes
GO to W2.
No
VERIFY the Smart Junction Box (SJB) fuse 19 (25A) (Sony(R) sound), or Battery Junction Box (BJB) fuse 20 (20A) or 21 (20A) (THX(R) sound)
is OK. If OK, REPAIR the circuit in question. If not OK, REFER to the Wiring Diagrams to identify the possible causes of the short circuit. CLEAR the
DTCs. REPEAT the network test with the scan tool. See: Diagrams/Electrical Diagrams/Diagrams By Number
-------------------------------------------------
W2 CHECK THE AUDIO DSP MODULE GROUND CIRCUITS FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable .
-
For THX(R) sound, measure the resistance between the audio DSP module, harness side and ground as follows: