Milan FWD L4-2.5L (2010)
![background image](/mercury/milan_fwd/l4-2.5l/Page-1287001.png)
Resonator: Service and Repair
Intake Air Resonator
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the LH fender splash shield.
3. Remove the 3 nuts and the intake air resonator.
-
To install, tighten to 15 Nm (133 lb-in).
4. NOTE: Make sure that the ACL inlet pipe is securely seated to the intake air resonator.
To install, reverse the removal procedure.