Milan FWD L4-2.5L (2010)
Oil Pressure Sender: Service and Repair
Engine Oil Pressure (EOP) Switch
Removal and Installation
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. If equipped, remove the 7 screws and the underbody cover.
Vehicles equipped with manual transaxle
3. Remove the 2 bolts and position the clutch slave cylinder aside.
-
To install, tighten to 22 Nm (16 lb-ft).
All vehicles
4. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
5. Remove the EOP switch.
-
To install, tighten to 15 Nm (133 lb-in).
6. To install, reverse the removal procedure.
-
Apply thread sealant to the EOP switch threads.