Milan FWD L4-2.5L (2010)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the battery tray. For additional information, refer to Battery Tray See: Service and Repair/Battery Tray.
3. Remove the bolt and position the battery cable body ground terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
4. Remove the nut and position the Battery Junction Box (BJB) cable terminal aside.
-
To install, tighten to 9 Nm (80 lb-in).
5. Disconnect the battery cable in-line harness connector from the engine compartment wiring harness and position aside.
6. Release the 2 wiring harness retainers from the body.
7. Disconnect the A/C compressor clutch field electrical connector and position aside.
8. Release the wiring harness retainer from the intake manifold.
9. Remove the starter solenoid terminal cover.
10. Remove the nut and position the battery cable starter solenoid terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
11. Remove the nut and position the starter motor solenoid wire terminal aside.
-
To install, tighten to 5 Nm (44 lb-in).
12. Remove the nut and position the battery cable transaxle ground terminal aside.
-
To install, tighten to 17 Nm (150 lb-in).
13. Release the wiring harness retainer from the transaxle stud bolt.
14. Disconnect the transaxle electrical connector and position aside.
15. Disconnect the turbine speed sensor electrical connector and position aside.
16. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
17. Disconnect the generator electrical connector and move aside.
18. Release the 3 battery cable locators from the valve cover.
19. Remove the battery cables.
20. To install, reverse the removal procedure.