mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Keyless Start System - Hard Start/Long Crank Time|Page 6183 > < Keyless Start System - Hard Start/Long Crank Time|Page 6177
Page 1
background image

Ground Strap: Customer Interest
Keyless Start System - Hard Start/Long Crank Time

TSB 09-19-1

10/05/09

2.5L ENGINE - INTERMITTENT HARD START / LONG
CRANK - WITH ONE TOUCH INTEGRATED SYSTEM
(OTIS)

FORD:
2010 Fusion, Fusion

MERCURY:
2010 Milan

This article supersedes TSB 9-15-10 to update the Title, Issue Statement, Service Procedure and Service Labor Time Standard.

ISSUE
Some 2010 Fusion and Milan vehicles built before 7/26/2009 and equipped with 2.5L engines may exhibit intermittent conditions of hard start or long
crank time. These conditions are present when cycling the key into the start position. The vehicle may also exhibit one touch instant start (OTIS) time out
concern with no diagnostic trouble codes (DTCs) present. These intermittent conditions may be caused by radio frequency interference (RFI)
intermittently corrupting the crankshaft position sensor (CKP) signal input while cranking.

ACTION
Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

Replace existing ground strap with revised capacitor ground strap.

1. Remove existing ground strap located on right hand side strut tower and discard.

Keyless Start System - Hard Start/Long Crank Time|Page 6183 > < Keyless Start System - Hard Start/Long Crank Time|Page 6177