Milan FWD L4-2.5L (2010)
2. From the scan tool, follow the on-screen instructions to ENTER SECURITY ACCESS. For additional information, refer to Anti-Theft Security
Access See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Component Tests and General Diagnostics
.
3. From the scan tool, select: Parameter Reset and follow the on-screen instructions.
4. NOTE: If the IPC or the IPC and the PCM were replaced, updated or reconfigured, follow Steps 4-9. All vehicle keys are erased during the
parameter reset procedure. Verify at least 2 vehicle keys are available prior to carrying out the PATS parameter reset. If only the PCM was
replaced, go to Step 9.
From the scan tool, select: Ignition Key Code Erase and follow the on-screen instructions.
5. Turn the key to the OFF position and disconnect the scan tool.
6. Turn the key to the ON position for 6 seconds.
7. Turn the key to the OFF position and remove the key.
8. Insert the second PATS key into the ignition lock cylinder and turn the key to the ON position for 6 seconds.
9. Both keys now start the vehicle.
10. If more keys are required to be programmed, refer to Key Programming Using Two Programmed Keys See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Key Programming Using Two Programmed Keys.
