Milan FWD L4-2.5L (2010)
Tie Rod: Service and Repair
Tie Rod - Inner
NOTE: Hydraulic Power Assist Steering (HPAS) shown, Electronic Power Assist Steering (EPAS) similar.
Removal and Installation
NOTICE: When servicing inner tie rods, a new bellows boot and clamps must be installed or a leak may occur causing steering gear damage.
1. Remove the steering gear. For additional information, refer to Steering Gear - 3.5L Front Wheel Drive (FWD) See: Steering Gear/Service and
Repair,
Steering Gear - 3.5L All Wheel Drive (AWD) See: Steering Gear/Service and Repair, Steering Gear - 2.5L Non-Hybrid and 3.0L Front Wheel Drive
(FWD) See: Steering Gear/Service and Repair or
Steering Gear - 2.5L Hybrid and 3.0L All Wheel Drive (AWD) See: Steering Gear/Service and Repair.
2. NOTICE: Position the steering gear in a soft-jaw vise or damage to the steering gear may occur.
Loosen the tie-rod jam nut and remove the outer tie-rod end.
-
To install, tighten to 80 Nm (59 lb-ft).