Milan FWD L4-2.5L (2010)
Installation
1. Inspect the bushing surface on the LH halfshaft and the LH halfshaft bushing in the transaxle case for damage or excessive wear. If the LH
halfshaft or the LH halfshaft bushing shows signs of excessive wear or damage, inspect the transaxle case for damage. Install a new LH halfshaft.
Install a new LH halfshaft bushing. For additional Information, refer to Transaxle case bushing.
-
If the LH halfshaft or the LH halfshaft bushing shows signs of excessive wear or damage but the transaxle case does not, install a new LH
halfshaft. Install a new LH halfshaft bushing. For additional Information, refer to Transaxle case bushing.
-
If the transaxle case is damaged, install a new LH halfshaft. Install a new transaxle case. For additional Information, refer to Transaxle - 2.5L
See: Service and Repair/Removal and Replacement/6F35/Removal - Transaxle or Transaxle - 3.0L See: Service and Repair/Removal and
Replacement/6F35/Removal - Transaxle and Transaxle See: Service and Repair/Overhaul/6F35/Disassembly - Transaxle.
-
If the bushing is not damaged or worn excessively, clean the area behind the seal and install a new seal following this procedure.
2. Install a new halfshaft seal on the Differential Seal Installer and Handle.
3. Using the Differential Seal Installer and Handle, install the LH halfshaft seal.
4. Install the front LH halfshaft. For additional information, refer to Drive Axles, Bearings and Joints.