Milan FWD L4-2.5L (2010)
10. Remove the upper 2 transaxle insulator-to-frame bolts and remove the transaxle insulator.
Installation
1. Clean the rear transaxle support insulator bolts using a wire brush and apply new threadlock to the threads.
2. Position the transaxle support insulator in place and install the upper 2 transaxle insulator-to-frame bolts.
-
Tighten to 62 Nm (46 lb-ft).
3. Install the transaxle insulator through bolt and flagnut.
-
Tighten to 150 Nm (111 lb-ft).
4. Remove the floor jack and the Oil Pan Holding Fixture.
5. Install the ACL. For additional information, refer to Engine.