Milan FWD L4-2.5L (2010)
3. Install the lower 2 transaxle support insulator bolts.
-
Tighten to 62 Nm (46 lb-ft).
4. Position the LH front structure-to-subframe splash shield in place and install the 6 pin-type retainers.
5. Position the LH splash shield in place and install the 4 screws.
6. Position the BJB and bracket in place and install the 2 bolts and the nut.
-
Tighten to 10 Nm (89 lb-in).
7. Install the electrical connector bracket on the BJB.