Milan FWD L4-2.5L (2010)
3. Remove the 3 PCM bracket nuts and the bracket.
4. Remove the clutch master cylinder nut.
5. Working under the instrument panel, disconnect the clutch switch (cruise control cancel) electrical connector.
6. Disconnect the Clutch Pedal Position (CPP) electrical connector.
7. Remove the clutch master cylinder nut and the clutch pedal bracket nut.
8. Remove the clutch pedal and bracket assembly.
Installation
1. NOTE: Make sure to align the push rod into the clutch master cylinder piston as the pedal assembly is installed.
Install the clutch pedal and bracket assembly
-
Apply a small amount of grease to the:
-
clevis bushing.
-
end of the clutch switch.
-
end of the master cylinder push rod.