Milan FWD L4-2.5L (2010)
Pilot Bearing: Service and Repair
Pilot Bearing
Removal
1. Remove the clutch disc and pressure plate. For additional information, refer to Clutch Disc and Pressure Plate See: Clutch Disc/Service and
Repair/Removal and Replacement.
2. Using the Pilot Bearing Remover, remove the pilot bearing.
3. Inspect the pilot bearing for:
-
misalignment and looseness in the flywheel.
-
needle rollers for scoring, worn or broken needle rollers, inadequate grease or discoloration.
-
seal leakage.
Installation
1. NOTE: The pilot bearing can only be installed with the seal facing the transmission. The pilot bearing is pregreased and does not require
additional lubrication. A new pilot bearing must be installed whenever it is removed.
Using a soft-face hammer and the Pilot Bearing Installer, install the pilot bearing.
2. Install the clutch disc and pressure plate. For additional information, refer to Clutch Disc and Pressure Plate See: Clutch Disc/Service and
Repair/Removal and Replacement.