Milan FWD L4-2.5L (2010)
5. Remove the intermediate shaft. For additional information, refer to Drive Axles, Bearings and Joints.
6. Using the Slide Hammer and RH Halfshaft Fluid Seal Remover, remove and discard the RH differential seal.
Installation
1. Using the Differential Seal RH and LH Installer (two sided tool eCVT) and Driver 32 Inch Handle, install the RH differential seal.
2. Install the intermediate shaft. For additional information, refer to Drive Axles, Bearings and Joints.
3. NOTE: Inspect the plug and washer for damage and install a new plug if necessary.
Clean the drain plug threads and install the drain plug.
-
Tighten to 40 Nm (30 lb-ft).
4. Remove the fill plug on the side of the transaxle.