Milan FWD L4-2.5L (2010)
1. NOTE: Make sure that the mating surface is clean before installing the new seal.
Using the Pinion Seal Replacer, install the drive pinion seal.
2. NOTE: Lubricate the pinion flange splines with grease.
Line up the index marks and position the pinion flange.
3. Using the Drive Pinion Flange Holding Fixture, install the new pinion flange nut.
-
Tighten to 244 Nm (180 lb-ft).
4. Install the driveshaft. For additional information, refer to Drive/Propeller Shafts, Bearings and Joints.