Milan FWD L4-2.5L (2010)
Fluid - M/T: Service and Repair
Transaxle Draining and Filling
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the drain plug and drain the fluid.
3. Install a new washer and the drain plug.
-
Tighten to 49 Nm (36 lb-ft).
4. NOTE: Prior to removal, clean the area of the fill plug.
Remove the fill plug.
5. NOTE: Do not overfill the transaxle. This may result in increased operating temperature or cause transaxle fluid to be forced out of the case.
Fill the transaxle with the recommended fluid.
6. Install a new washer and fill plug.
-
Tighten to 49 Nm (36 lb-ft).