Milan FWD L4-2.5L (2010)
![background image](/mercury/milan_fwd/l4-2.5l/Page-1588004.png)
7. Position the PDB in place. Connect the 2 electrical connectors.
8. Push the PDB downward to clip the pushpin. Install the 2 PDB bolts and the lower nut.
9. Install the battery tray and battery. For additional information, refer to Battery.
10. Install the 2 lower transaxle rear support insulator-to-frame bolts.
-
Tighten to 63 Nm (46 lb-ft).
11. Install the splash shield and the 7 splash shield bolts.
-
Tighten to 9 Nm (80 lb-in).