Milan FWD V6-3.0L (2010)
6. Inspect the BLIS exterior rear view mirrors glass subassembly connectors for spread or damaged terminals. (Figures 2-3):
a. If the terminals are damaged at the exterior rear view mirror glass subassembly, replace the exterior rear view mirror assembly. Refer to WSM,
Section 501-09.
b. If no damage is found, verify terminal pins are clean and tight.
(1) Place a dab of Motorcraft(R) Electrical Grease on the front and rear of the female terminal connectors.
(2) Place a dab of Motorcraft(R) Electrical Grease on the rear of the male terminal connector to create a weather tight seal. (Figures 2-3)
(3) Re-install appropriate exterior rear view mirrors glass subassemblies per WSM, Section 501-09.
(4) Proceed to Step 7.
7. Use the exterior mirror control switch for proper control operation, cycle the mirrors up and down and left and right, stalling the mirror for 5 seconds
at each position. Use the scan tool and check for any SOD faults. If no faults are present, return the vehicle to the customer; the vehicle is fixed. If
B11D6:15 fault is still present, proceed to Step 8.
8.
For Taurus vehicles built on or before 5/11/2010, MKT vehicles built on or before 5/05/2010, and Fusion, Milan and MKZ vehicles built
prior to 5/21/2010, replace the appropriate exterior left and/or right side complete mirror assembly per WSM Section 501-09. Refer to the
parts list for the correct mirror application.