Milan FWD V6-3.0L (2010)
4. After inputting the dip switch settings, at the same time, press and release all 3 Lear Car2U(R) System buttons. The 3 red indicator lights are
turned on continuously.
5. Press and hold the Lear Car2U(R) System button you would like to use to control the garage door.
6. Once the garage door starts to move, within one second, release the button. During this time, the selected button indicator light blinks slowly. Do
not release the button until the garage door moves, which may take anywhere from 5-55 seconds, depending on the make/model of the garage door
opener.
7. The 3 red indicator lights begin to blink rapidly until programming is complete. If the garage door opener does not operate, repeat Steps 1-6.
-
For technical assistance, refer to the Owner's Literature.
8. After successful programming, the Lear Car2U(R) System operates the garage door opener using the button that was programmed. The red
indicator light in front of the programmed button turns on to confirm the Lear Car2U(R) System is responding (and is programmed) to the button
command.
Erasing the Lear Car2U(R) System Buttons (Fixed Code) - Late Build
1. To erase the fixed code programming from the Lear Car2U(R) System, turn the ignition key to the on position, firmly press and hold the 2 outside
Lear Car2U(R) System buttons at the same time for approximately 20 seconds until the 3 red indicator lights begin to blink rapidly.
2. When the 3 red indicator lights begin to blink, release the buttons. The codes for all of the 3 buttons are erased.
