Milan FWD V6-3.0L (2010)
Position the seat forward so the seat track bracket does not engage the safety belt buckle and pretensioner bracket attached to the cushion frame. See
Figure 2.
6. WARNING: The occupant classification sensor (OCS) rails have a built-in strain gauge which may operate incorrectly if an OCS rail is dropped by
itself, dropped after it is installed to the front passenger seat or dropped after it is installed to a front passenger seat track assembly Use care when
handling an OCS rail before or after it is installed to the front passenger seat or seat track assembly. Failure to follow these instructions may result in
incorrect operation of the OCS system and increases the risk of serious personal injury or death in a crash.
Remove the seat from the vehicle.
1. Remove the two seat track-to-floor rear bolt covers.
2. Remove and discard the four seat track-to-floor bolts.
3. Tip the seat rearward.
4. Release the seat wire harness pushpin.
5. Disconnect the seat electrical connector.
Disassembly