Milan FWD V6-3.0L (2010)
-
To install, tighten to 25 Nm (18 lb-ft).
2. Disconnect the brake tube fitting from the brake flexible hose.
-
To install, tighten to 17 Nm (150 lb-in).
3. Remove the brake flexible hose bracket-to-wheel knuckle bolt.
-
To install, tighten to 23 Nm (17 lb-ft).
4. Remove the brake flexible hose bracket-to-body bolt and the brake flexible hose.
-
To install, tighten bolt to 18 Nm (159 lb-in).
5. To install, reverse the removal procedure.
-
Install new copper washers.
-
Bleed the brake caliper. For additional information, refer to Component Bleeding in Brakes and Traction Control.
