Milan FWD V6-3.0L (2010)
Replacement/Lower Intake Manifold.
5. Remove the bolt and position aside the ground wire.
-
To install, tighten to 10 Nm (89 lb-in).
6. Remove the bolt and damper.
-
To install, tighten to 23 Nm (17 lb-ft).
7. Remove the engine support insulator bracket bolt.
-
To install, tighten to 115 Nm (85 lb-ft).
8. Install the Engine Support Bar, Universal Adapter Brackets and a suitable piece of chain.
1. Position the 2 Universal Adapter Brackets on top of the cylinder block.
2. Install 2 M8 x 1.25 x 36 mm (1.41 in) bolts and tighten to 10 Nm (89 lb-in).
3. Use a suitable piece of chain.
4. Fasten the chain to the 2 Universal Adapter Brackets with a suitable nut, washer and bolt.
9. Using the Engine Support Bar, lift the engine 12 mm (0.47 in).
10. Remove the 3 nuts and the engine support insulator bracket.
-
To install, tighten to 63 Nm (46 lb-ft).
11. Remove the nut, 2 bolts and the engine mount.
-
To install, tighten to 55 Nm (41 lb-ft).