Milan FWD V6-3.0L (2010)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the EGR tube. For additional information, refer to Emission Control Systems.
3. Remove the RH catalytic converter. For additional information, refer to Exhaust System &/or Catalytic Converter.
4. NOTE: The heat shield that was unbolted from the exhaust manifold during removal of the RH catalytic converter cannot be removed from the
vehicle until the Power Transfer Unit (PTU) bracket is removed.
Remove the 5 bolts and the PTU bracket.
-
Remove the catalytic converter heat shield from the vehicle.
5. Remove the 6 nuts and the RH exhaust manifold.
-
Discard the gasket and nuts.
6. Clean and inspect the RH exhaust manifold. For additional information, refer to Engine.
7. Remove and discard the 6 RH exhaust manifold studs.
8. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These may
cause scratches and gouges resulting in leak paths. Use a plastic scraper to clean the sealing surfaces.
Clean the exhaust manifold mating surface of the cylinder head with metal surface prep. Follow the directions on the packaging.
Installation
1. Install 6 new RH exhaust manifold studs.
-
Tighten to 12 Nm (106 lb-in).