mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 9554 > < Initial Inspection and Diagnostic Overview|Page 9552
Page 8
background image

-

Is the voltage greater than 10 volts?

Yes

GO to A14.

No

VERIFY the SJB fuse 41 (15A) is OK. If OK, REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation. If
not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short  See: Diagrams/Electrical Diagrams/Diagrams By Number.

-------------------------------------------------
A14 CHECK THE MIRROR GROUND CIRCUIT FOR CONTINUITY (VEHICLES WITH VIDEO MIRROR)

 

-

Ignition OFF.

-

Disconnect: Negative Battery Cable.

-

Measure the resistance between the auto-dimming interior mirror C9039-3, circuit GD139 (BK/YE), harness side and ground.

-

Is the resistance less than 5 ohms?

Yes

GO to A15.

No

REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.

-------------------------------------------------
A15 CHECK THE COMMUNICATION CIRCUITS FOR A SHORT TO VOLTAGE (VEHICLES WITH VIDEO MIRROR)

 

-

Disconnect: IPC C220.

-

Connect: Negative Battery Cable.

-

Ignition ON.

-

Measure the voltage between the auto-dimming interior mirror C9039-10, circuit VMC30 (BU/GY), harness side and ground; and between the
auto-dimming interior mirror C9039-9, circuit VMC31 (GY/BU), harness side and ground.

Initial Inspection and Diagnostic Overview|Page 9554 > < Initial Inspection and Diagnostic Overview|Page 9552