mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3226 > < Initial Inspection and Diagnostic Overview|Page 3224
Page 94
background image

If the vehicle is not equipped with an FDIM, GO to AC17. 

No

CONNECT the negative battery cable. GO to AC57.

-------------------------------------------------
AC16 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE FDIM DISCONNECTED

 

-

Disconnect: FDIM C2407 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AC17. 

No

CONNECT the negative battery cable. GO to AC58.

-------------------------------------------------
AC17 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE HVAC MODULE
DISCONNECTED

 

-

Disconnect: HVAC Module C2357a (Manual) or C2356a (Dual Automatic Temperature Control (DATC)) .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a Global Positioning System Module (GPSM), GO to AC18. 

If the vehicle is not equipped with a GPSM, GO to AC19. 

No

CONNECT the negative battery cable. GO to AC59.

-------------------------------------------------
AC18 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE GPSM DISCONNECTED

 

-

Disconnect: GPSM C2300 .

Initial Inspection and Diagnostic Overview|Page 3226 > < Initial Inspection and Diagnostic Overview|Page 3224