Milan FWD V6-3.0L (2010)
-
Verify whether the vehicle is equipped with side obstacle detection.
-
Is the vehicle equipped with side obstacle detection?
Yes
GO to AC51.
No
REPAIR the circuits. CONNECT all modules. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
AC51 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE SOD-L DISCONNECTED
-
Disconnect: Side Obstacle Detection Control Module - Left (SOD-L) C4230 .
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to AC67.
No
GO to AC52.
-------------------------------------------------
AC52 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE SOD-R DISCONNECTED
-
Disconnect: Side Obstacle Detection Control Module - Right (SOD-R) C4229 .
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to AC68.
No
REPAIR the circuit. CONNECT all modules. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
AC53 CHECK FOR CORRECT SJB OPERATION
