mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3262 > < Initial Inspection and Diagnostic Overview|Page 3260
Page 130
background image

No

CONNECT the negative battery cable. GO to AE48.

-------------------------------------------------
AE21 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE TCM DISCONNECTED

 

-

Disconnect: TCM C1458a (Hybrid) or C1533 (3.5L) .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AE22. 

No

CONNECT the negative battery cable. GO to AE49.

-------------------------------------------------
AE22 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE IPC DISCONNECTED

 

-

Disconnect: IPC C220 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to AE23. 

If the vehicle is not equipped with an APIM, GO to AE24. 

No

CONNECT the negative battery cable. GO to AE50.

-------------------------------------------------
AE23 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE APIM DISCONNECTED

 

-

Disconnect: APIM C3338 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

Initial Inspection and Diagnostic Overview|Page 3262 > < Initial Inspection and Diagnostic Overview|Page 3260