Milan FWD V6-3.0L (2010)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these
charges.
NOTICE: Do not allow any brake fluid or foreign material to enter the mating side of the Anti-lock Brake System (ABS) module or damage to
the solenoids can occur.
1. If a new ABS module is being installed, connect the scan tool and upload the module configuration from the ABS module. For additional
information, refer to Information Bus.
2. Remove the degas bottle. For additional information, refer to Cooling System &/or Engine Block Heater.
3. Disconnect the ABS module electrical connector.
4. Remove the 4 ABS module screws and the ABS module.
-
To install, tighten to 2 Nm (18 lb-in).
5. NOTE: Visually inspect the ABS module terminals for damage before installation.
To install, reverse the removal procedure.
6. If a new ABS module was installed, download the module configuration information from the scan tool. For additional information, refer to
Information Bus.
