Milan FWD V6-3.0L (2010)
-
C2780 (ECU in Manufacturer Sub-State)
1. NOTE: This step is only necessary if the SJB is being replaced.
Upload the module configuration information from the SJB into the scan tool. For additional information, refer to Information Bus.
2. Disconnect the 7 electrical connectors.
3. Lift the SJB locking tab outward and slide the SJB upward to disengage it from the SJB bracket.
Installation
1. Position the SJB into the 3 keyholes of the SJB bracket and slide it downward until the SJB locking tab snaps into place.
2. NOTE: If the SJB is not being replaced, this is the last step that is necessary.
Connect the 7 electrical connectors.
3. NOTE: When successful, this step provides the calibration necessary for the SJB operation and clears the DTCs B106D and B2477. The clearing
of these DTCs indicates the calibration data has been successfully downloaded to the SJB.
NOTE: If the Programmable Module Installation (PMI) procedure was not followed when a new SJB was installed, the Remote Keyless Entry
(RKE) function (from the Integrated Keyhead Transmitter (IKT)) of the SJB must be programmed, or the IKT RKE functions is inoperative. IKTs
can be programmed to the new SJB by cycling each IKT key to the ON position for a minimum of 6 seconds. If a new Instrument Panel Cluster
(IPC) was installed, the IKT keys must be programmed to the new IPC. For additional information, refer to Antitheft and Alarm Systems.
NOTE: DTC B2276 may be set, indicating there are less than 2 transmitters programmed to the SJB. For additional information, refer to Doors,
Hood and Trunk &/or Locks.
Download the SJB configuration information from the scan tool to the SJB. For additional information, refer to Information Bus.
4. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the SJB has recognized
the tire pressure sensors during the training procedure.
Train the tire pressure sensors. For additional information, refer to Wheels and Tires.
5. NOTE: DTC C2780 cannot be cleared if any other DTCs are present in the SJB. When successful, this step clears the DTC C2780.
Carry out the SJB self-test (must include an on-demand self-test) by clearing the DTCs, and then retrieving the DTCs to confirm all DTCs have
been cleared.
