Milan FWD V6-3.0L (2010)
buttons released, remove the electrical connectors and the driver air bag module.
Installation
1. NOTICE: The driver air bag module electrical connector locking buttons must be in the released position when connected. Do not install
the driver air bag module electrical connectors by the locking buttons. Failure to follow these instructions may cause connector damage.
With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking
buttons.
2. Align the driver air bag module locking pins to the steering wheel and, while pushing inward, seat the 2 driver air bag module locking pins to the
steering wheel wire clips.
3. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion.
