Milan FWD V6-3.0L (2010)
Removal and Installation
1. Disconnect the 12-volt battery. For additional information, refer to Battery.
2. Remove 4 pin-type retainers and the front trunk cover.
3. NOTE: If the center safety belt retractor locks and the safety belt webbing prevents the 60 percent backrest from lowering, raise the backrest
upward to release the safety belt retractor and belt webbing.
Fold the RH backrest down.
-
Between the High Voltage Traction Battery (HVTB) and the sheet metal, locate the seat backrest latch release lever.
-
Push the release lever toward the outboard side of the vehicle and fold the backrest down.
4. Remove the RH rear seat bolster. For additional information, refer to Seats.
5. Disconnect the 2 electrical connectors at the DC/AC inverter.
6. Remove the 3 nuts and the DC/AC inverter.
-
To install, tighten to 9 Nm (80 lb-in).
7. To install, reverse the removal procedure.