Milan FWD V6-3.0L (2010)
Steering Wheel: Service and Repair
Steering Wheel Bezel
Steering Wheel Bezel
Removal
NOTICE: The center steering wheel bezel is manufactured using plastic wrapped with aluminium and is very fragile. The removal and
installation procedure must be followed exactly as outlined or damage to the bezel can occur.
NOTICE: Use a plastic trim removal tool or a plastic-coated tool when removing the bezel to avoid damaging the steering wheel.
1. Remove the driver air bag module. For additional information, refer to Restraint Systems.
2. Using a plastic trim removal tool, carefully separate the bezel from the steering wheel in the following order:
1. Upper RH corner
2. Lower RH corner
3. Lower LH corner
4. Upper LH corner
3. NOTE: There are a total of 10 pins that secure the bezel to the steering wheel, 4 along the top of the bezel, 2 along the bottom and 2 on each side
in the corners.
Using a plastic trim removal tool, carefully remove the bezel from the steering wheel in the following order:
1. Top 4 pins