Milan FWD V6-3.0L (2010)
Clutch disc and clutch pressure plate
4. Apply a very small amount of grease in the clutch disc hub. Wipe off excess grease to avoid contaminating the clutch disc and affecting clutch
function.
5. Using a suitable clutch disc aligner, position the clutch disc on the flywheel.
6. Position the clutch pressure plate on the flywheel and to the dowels. Install the 6 clutch pressure plate bolts.
-
Tighten the bolts one turn at a time in a star pattern. Tighten to 29 Nm (21 lb-ft).
7. Apply a small amount of grease to:
-
the clutch release fork fingers.
-
the clutch release fork spring.
-
the guide tube.
-
the clutch slave cylinder end that contacts the release fork.
8. NOTE: Apply a very small amount of grease to the transmission input shaft end and on the splines.
Install the transaxle.