Milan FWD V6-3.0L (2010)
Differential Cover: Service and Repair
Differential Housing Cover
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the 10 bolts and the differential housing cover.
-
Drain the differential fluid from the housing.
Installation
1. NOTICE: Make sure the machined surfaces on the rear axle housing and the differential housing cover are clean and free of oil before
installing the new silicone rubber. The inside of the rear axle must be covered when cleaning the machined surface to prevent damage to
the component.
