Milan FWD V6-3.0L (2010)
NOTE: RH rear shown.
Removal and Installation
Fusion, Milan
1. Remove the access cover and the screw.
2. Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward and then shift the switch assembly rearward to disengage the
front locking tab.
MKZ
3. NOTE: For LH front window control switch assembly only, the rear retaining clip is located off-center towards the outside of the vehicle.
Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward to disengage the retaining clip, then shift the switch assembly
rearward to disengage the front locking tab.
All Vehicles
4. Disconnect the electrical connector(s).
5. Remove the window control switch.
6. To install, reverse the removal procedure.