Milan FWD V6-3.0L (2010)
urethane adhesive bond.
Using the alignment marks made previously, position the windshield glass on the pinch weld.
11. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
After the urethane adhesive has cured, check the windshield glass seal for air or water leaks through the urethane adhesive bead and add urethane
adhesive as necessary.
12. Install the cowl panel grille.
13. Install the headliner.
14. If equipped, install the rain sensor. For additional information, refer to Wiper and Washer Systems.
15. Install the interior mirror. For additional information, refer to Mirrors.
16. Install the sun visors.
17. Install the A-pillar trim panels.
