Montego AWD V6-3.0L VIN 1 (2005)
Seat Track: Service and Repair
SEAT TRACK - FRONT
Worldwide Diagnostic System (WDS)
Special Tool(s)
Removal and Installation
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION: It is necessary to rezero the occupant classification sensor (OCS) system when a front passenger seat cushion is disassembled, a
new trim cover is installed, or an OCS service kit is installed. A diagnostic tool is used to trigger the active command to carry out rezeroing of
the OCS system.
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the supplemental restraint system (SRS) must be
depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
The memory seat track position sensors are integral to the memory seat track motors. The memory seat track motor electrical connectors will
connect to a seat track without the memory option. Make sure the correct seat track is being installed.
All seats
1. Position the seat to access all the seat track-to-floor pan bolts and the safety belt anchor.
2. Depower the SRS.
3. Remove the front seat.
Seats with manual recline
4. Pull out and remove the manual recline handle.
Power seats
5. Remove the seat control switch knob.
Seats with power recline
6. Remove the power backrest adjust knob.
All seats
7. Remove the rear screw, pull out on the side and front and separate the side shield.
-
Vehicles with manual seats, remove the side shield.
Power seats
8. Release the seat control switch wire harness pin-type retainer. Remove the seat control switch, disconnect it and remove the side shield.
Passenger seats
9. Separate the safety belt tension sensor electrical connector from the seat track.
Heated seats
10. Disconnect the cushion heated seat element electrical connector.
All seats
11. Separate the pin-type retainer and disconnect the buckle switch electrical connector.
12. Release all cushion trim cover-to-seat cushion pan J-clips.
13. Release the hook and loop strip at the rear of the cushion trim cover.