Montego AWD V6-3.0L VIN 1 (2005)
Rocker Arm Assembly: Service and Repair
Camshaft Roller Follower Removal and Installation
Camshaft Roller Follower
Special Tools And Equipment
Special Tool(s)
Material
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the LH and RH valve covers.
3. Remove the 6 spark plugs.
^
To install, tighten to 15 Nm (11 ft. lbs.).
4. Remove the RH splash shield.
^
To install, tighten to 9 Nm (80 inch lbs.).
5. Rotate the crankshaft until the camshaft lobe is pointing directly away from the roller follower.
6. Using the special tool, remove the roller followers.
7. NOTE: Lubricate the camshaft followers with clean engine oil.
To install, reverse the removal procedure.