Montego AWD V6-3.0L VIN 1 (2005)
^
To install, clean the bolt using a wire brush, apply new threadlocker to the threads and tighten to 48 Nm (35 ft. lbs.).
4. Remove the 4 roll restrictor cross brace-to-strut tower bolts and the crossbar.
^
To install, clean the bolts using a wire brush, apply new threadlocker to the threads and tighten to 55 Nm (41 ft. lbs.).
5. Remove the 4 roll restrictor support bracket bolts and the support bracket.
^
To install, clean the bolts using a wire brush, apply new threadlocker to the threads and tighten to 55 Nm (41 ft. lbs.).
6. Detach the wiring retainer from the roll restrictor.
7. Remove the 2 bolts and the roll restrictor.
^
To install, clean the bolt using a wire brush, apply new threadlocker to the threads and tighten to 55 Nm (41 ft. lbs.).
8. To install, reverse the removal procedure.