Montego AWD V6-3.0L VIN 1 (2005)
4. Disconnect the fuel tube redundant clip.
5. Press the fuel tube quick release coupling button and disconnect the fuel tube from the fuel rail.
6. Disconnect the fuel rail pressure and temperature sensor electrical connector and vacuum tube.
7. Disconnect the fuel charging wiring harness electrical connector.
8. Remove the lower intake manifold.
Installation
1. NOTE: Clean and inspect all sealing surfaces. Inspect and install new gaskets as necessary.
Position the lower intake manifold.
2. Connect the fuel charging wiring harness electrical connector.
3. Connect the fuel rail pressure and temperature sensor electrical connector and vacuum tube.
4. CAUTION: Make sure that the fuel tube coupling clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull
on the tube.
NOTE: Apply clean engine oil to the end of the tube before inserting a tube into the connector.
Connect the fuel tube to the fuel rail.
