Montego AWD V6-3.0L VIN 1 (2005)
2. Remove the 8 upper grille retainers.
3. Release the 4 lower grille clips and remove the grill.
Five Hundred and Montego front impact severity sensor
4. Remove the 6 retainers and carefully position out the upper air deflector.
All vehicles
5. WARNING: The tightening torque of the air bag front impact severity sensor retaining nuts is critical for correct system operation.
NOTE:
-
Make sure the radiator support and front impact severity sensor mating surfaces are clean and debris free.
-
Note position of locator tab on sensor for installation.
Remove the front impact severity sensor bolt.
-
To install, tighten to 12 Nm (9 lb-ft).
6. Disconnect the front impact severity sensor electrical connector and remove the sensor.
7. To install, reverse the removal procedure.
8. Repower the system.