Montego AWD V6-3.0L VIN 1 (2005)
12. CAUTION: Do not oversize the seat cushion frame holes used to rivet the ECU in place.
Separate the occupant classification sensor (OCS) components from the seat cushion frame.
1
Cut the tie strap.
2
Remove the rivets with a 5-mm (3/16-inch) drill and separate the electronic control unit (ECU) from the seat cushion frame bracket.
3
Bend and release the retaining tab holding the pressure sensor in place.
4
Slide the pressure sensor off the bracket.
5
Release the pin-type retainer and disconnect the electrical connector.
Seats with manual seat track
13. CAUTION: Do not oversize the seat cushion frame holes used to rivet the ECU in place.
Separate the occupant classification sensor (OCS) components from the seat cushion frame.
1
Cut the tie strap.
2
Remove the rivets with a 5-mm (3/16-inch) drill and separate the electronic control unit (ECU) from the seat cushion frame bracket.
3
Bend and release the retaining tab holding the pressure sensor in place.
4
Slide the pressure sensor off the bracket.