Montego AWD V6-3.0L VIN 1 (2005)
Child Seat Tether Attachment: Service and Repair
CHILD SAFETY SEAT TETHER ANCHOR - LATCH
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), if equipped, shoulder
belt height adjusters, if equipped, child safety seat tether bracket assemblies, if equipped, and attaching hardware should be inspected after any
collision. All belt assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt
assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.
The Automatic Locking Retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR
feature for a child seat is functioning properly, in addition to the other checks for proper safety belt system function. A belt and retractor
assembly must be replaced if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating
properly when inspected according to the functional inspection procedures. Failure to replace the belt and retractor assembly could increase
the risk of injury in collisions.
1. Remove the rear seat cushion.
2. Remove the 2 nuts and the affected LATCH.
-
To install, tighten to 48 Nm (35 lb-ft).
3. To install, reverse the removal procedure.