Montego AWD V6-3.0L VIN 1 (2005)
![background image](/mercury/montego_awd/v6-3.0l_vin_1/Page-1867004.png)
6. Remove the fluid level indicator and wipe it with a clean lint free rag. Place the fluid level indicator back into the fluid level indicator tube.
7. Remove the fluid level indicator and check for correct fluid level. The fluid level should be at the bottom of the top level indicator hole with the
CVT automatic transmission fluid temperature in the 43°C - 47°C (109°F - 117°F) range.
8. If fluid needs to be added, add clean CVT automatic transmission fluid in 0.25-Liters (1/2-pint) increments through the fluid fill plug located on
the top of the transaxle near the fluid level indicator. Do not over fill the transaxle and make sure the fluid temperature is in the correct range 43°C
- 47°C (109°F - 117°F) or internal damage to the transaxle will occur.
^
To install, tighten to 35 Nm (26 ft. lbs.).
^
The wrench light on the dash will illuminate if the fluid level is low during the fluid refill process and the vehicle may experience harsh
engagements.