Montego AWD V6-3.0L VIN 1 (2005)
7. Remove the 2 assist handle screws and the assist handle.
8. Lower the front portion of the headliner and block with a suitable material.
9. Clean the interior and exterior of the windshield glass surface with non-alcohol based glass cleaner.
10. Cut the urethane adhesive applicator tip to 6 mm (0.23 in).
11. NOTE:
-
Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
-
Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
Apply urethane adhesive over top of the existing urethane adhesive.
-
Apply the urethane to the top and sides of the windshield from the interior of the vehicle.
-
Apply the urethane to the bottom of the windshield from the exterior of the vehicle.
12. CAUTION: The urethane adhesive must cure for a minimum of 1 hour before testing for air or water leaks.
After the urethane has cured, check the windshield seal for air or water leaks through the urethane bead and add urethane adhesive as necessary.
13. Position the front portion of the headliner.
14. Position the LH and RH assist handles and install the 2 screws.
15. Close the assist handle screw covers.
16. If equipped, install the overhead console.